Leggett & Platt INST-A-MATIC Assembly Instructions

SUPPORT until SPRING CLIP locks in place as detailed in Figure 3.

Tap PLASTIC INSERT into ROUND LEG. Snap GLIDE BASE onto GLIDE EXTENSION.

Tap glide assembly into PLASTIC INSERT. See Figure 4.

CENTER LEG

Snap GLIDE BASE onto GLIDE EXTENSION. Install glide assembly as shown in Figure

5, making sure that the LEG fits into the notch on top of glide.

SPRING CLIP

Install rollers as shown in Figure 6. Locking rollers, if provided should be placed on the

corners at the foot of the bed.

INST-A-MATIC

For headboard-only and no-headboard style frames:

For 6-legged frames:

For 5-legged frames:

For frames with round center legs:

For frames with glides:

For frames with rollers:

WARNING: When attaching this frame to a headboard

with narrow posts, it is recommended that any excess

bolt be cut after attachment. See Figure 7.

DO NOT SCALE DRAWING

SHEET 1 OF 1

Related Manuals for Leggett & Platt INST-A-MATIC

Foldable base q/k/ck (16 pages)

Adjustable base (6 pages)

1 piece models (19 pages)

Foldable base (8 pages)

Inflating and deflating instructions sofa sleep system air over coil technology (2 pages)

Adjustable beds (24 pages)

Summary of Contents for Leggett & Platt INST-A-MATIC

• Page 1 INST-A-MATIC Figure 1 ASSEMBLY INSTRUCTIONS SIDE RAIL Step 1 Assemble CROSS ARMS to SIDE RAILS as shown in Figure 1. CROSS END CAP (For headboard-only & no-headboard Step 2 For headboard-only and no-headboard style frames: style frames.) Slide END CAPS onto SIDE RAILS. Warning: End caps must be placed over ends of side rails to avoid serious injury.
• Page 2 GL10 ASSEMBLY INSTRUCTIONS For Inst-A-Matic Bedframes: Step 1: Insert stem of GLIDE EXTENSION into leg of bedframe and place BASE onto GLIDE EXTENSION as shown in Figure 1. Step 2: Make sure that the notch of the GLIDE EXTENSION is turned so that the leg of the bedframe is properly GLIDE inserted as detailed in Figure 2.